Last seen: 2023-02-17 4:18 pm
I haven't used the transmitter in years, I graduated to solid state transceivers. It still has the famous 6146 main RF driver tube. I have other h...
Building Heathkits sure dates you. Good luck on your new adventure. Still have my old DX35 used for ham radio.
Welcome aboard
Thanks Ron for your input. I've done it both ways. Using the support board I power and flash using just USB port.
Hi Ron; Take a closer look, the pics show two boards, one is the CAM board, and the other is the USB with reset button and boot button. I power the...
This is photo of ESP32 CAM I purchased from Amazon. I hope this helps. I've had no problem Flashing the ESP32 CAM board.
Ron, Thanks, I downloaded Arduino 2.0 and started using it. Side note: There's complaints using the CAM board on breadboards because RST buttons and...