Notifications
Clear all
Help Wanted
7
Posts
3
Users
0
Likes
1,943
Views
Topic starter
2019-10-26 11:41 pm
I posted a video of my problem on YouTube under wishicould arduino duce robot build discription people and blog's if anybody has an answer you'll be a genius a legend thanks for any help in advance
2019-10-27 11:01 am
Hi @duce-robot , could you post your Configuration.h and the reference of your LCD (or datasheet or anything describing the model) ?
Eric
Topic starter
2019-10-27 11:31 am
LCD is rep rap full graphic discount smart controller I enabled it added the u8glib the config .h is pretty strait toward board ramps1.4 efb 3950 thermistor s max temp motors LCD unless I need to enable something in power .? Still no power to fan or bed or nozzle.
2019-10-27 2:15 pm
I suppose you have a suitable power supply for the Ramps ? I think some use 24v and others use 12v ?
Eric
Topic starter
2019-10-27 3:55 pm
That's a good observation I didn't consider that its a cheap board but I'll check it wouldn't surprise me my power supplies either one
2019-10-28 9:48 am
I haven't built a printer from parts, but, I've worked on mine enough to know that the LCD gives you a LOT of feedback information. If it were me, I'd try to get the LCD screen and the buttons on the control panel working first, and have IT tell you what's wrong
I like to start with the basics, and then slowly add levels of complexity step by step, and don't move on to the next step until you have the last step functioning
If you just put everything together, without testing anything, the problem could be anywhere, and it could take you forever to find it
Topic starter
2019-10-28 12:32 pm
I have been testing the code on a separate ramps mega and LCD . but I also discovered that not only does the panda have the arduino but a modeler and slicer built in and marlin like works well with it who knew ?so I'm going to run some code from that which is about a foot from the printer later on and see how it works .