Windows 10.

Which GPIO pin are you using on the ESP32 CAM? Ar you using software or hardware button debouncing?

rc7 takes forever to load for me, and often never actually loads until I interact with the window in some way. Otherwise the splash image stays there ...

@azflyer - if this is your error message then check the spelling of the variables in your code. You may have mistyped "positive" and written "posetive...

No, don't do that. That's quite normal. The modem from my ISP has an IP address of 192.168.0.1 and anything that connects to it is 192.168.0.xxx.

That's exactly what he is saying. 👍

Been there, done that, bought the t-shirt many, many times! You are not alone! 😀

I want to get some piezoelectric sensors and make some electronic drums. 😀 Dream on!

I tested the OUT pin.

I just tested this and it only outputs exactly 3.3V, regardless of my distance from the sensor. I don't know if the two are related, but I stumb...

I didn't realise the output voltage was dependent on the distance of the subject. I'll have to investigate this with my toy scope. Thanks @zander.

That makes sense. I'd read that it can detect motion from both sides so I thought the direction it faced was irrelevant. I'm not sure that's true thou...

Which side of the 0516 is the front and which is the back? Rather which side should face the area you want to detect motion? The side with the pin mar...

I haven't watched this video yet (sorry!) but I do have a quick question or two. Is pin 2 triggered (pin 3 goes high) by a falling edge? What happens ...