Hi again. I thought you stated in your post dated 2021-06-02 "i finally got the camera to work" and then went on to say how using 5V source solved t...

Hi both, good news for you Joel, you gotta keep messing. As @Spyder confirms, posting your code is essential to fault finding. Similar error messag...

Hi, I'm sorry, photos of your screen show the error ok but why can you not put the actual code from your sketch up as requested please. Its the cod...

@ drjoelleon I have not seen that error message before, so am unsure what initiates it in your code. The cleaning of camera contacts arises from err...

Welcome to you. I sort of know the area, my father in law lived high in the Cotswolds and insisted on flying to us here on the IOM from Gloucester, hi...

Hi, I recently obtained two ESP32-cam units, from the same source but different manufacturer's boards, one is by an unknown maker the other 'diymore'....

@codecage That idea is worth copying, thank you for sharing. Up till now I usually put a string tied label with what code/project the Arduino was b...

codecage and WolfgangW Was just about to state the same thing. I'm using library Remote.h version 2.1 from 1999! I was about to view in PlatformIO...

Hi Wolfgang, here we go. I set up a VS1838b onto breadboard and connected as you have BUT no resistors etc just three wires. My remote is labelled a...

Hi Bill, great video as always and I've now got PlatformIO up and runnng. Q. During the video you demostrated a sketch from the Arduino IDE that com...

Hi, my mistake on the link, should have deleted all after the ? which followed .pdf I'll re-set a breadboard and run code via Aduino IDE I used and ...

Greetings WolfgangW, I hope this might assist you. I once had a voluntary job as a stage hand at a local pantomime. They wanted UV lighting across t...

Hi John, I have encountered this problem before of to0 many LEDs off of one board and reaching the boards power supply limit of 200ma. Even getting ...