Notifications
Clear all

code is not upload on ESP32 ON ARDDUINO IOT CLOUD


taha
 taha
(@taha)
New Member
Joined: 2 weeks ago
Posts: 3
Topic starter  

 @DroneBot Workshop

ON MY ARDUINO IOT CLOUD CONSOLE  IT SHOWS LIKE THIS...

WARNING : ibrary arduinoiotcloud_1_2_1 claims to run on mbed, samd, esp8266, mbed_nano, mbed_portenta architecture(s) and may be incompatible with your current board which runs on esp32 architecture(s).

 

HOW CAN I RESOLVE THIS PROBLEM, I AM USING WINDOWS 10


Quote
Will
 Will
(@will)
Honorable Member
Joined: 4 months ago
Posts: 647
 
Posted by: @taha

 @DroneBot Workshop

ON MY ARDUINO IOT CLOUD CONSOLE  IT SHOWS LIKE THIS...

WARNING : ibrary arduinoiotcloud_1_2_1

[snipt]

may be incompatible with your current board which runs on esp32 architecture(s).

 

HOW CAN I RESOLVE THIS PROBLEM, I AM USING WINDOWS 10

Maybe use a compatible board instead ?


ReplyQuote
taha
 taha
(@taha)
New Member
Joined: 2 weeks ago
Posts: 3
Topic starter  

@will 

I am already used a compatible board ESP32 DEV MODULE, and in my first attempt It properly runs, but after that, they showing such an error


ReplyQuote
Will
 Will
(@will)
Honorable Member
Joined: 4 months ago
Posts: 647
 

@taha 

That sounds very strange. Perhaps the board was damaged during a previous use.

First, You should load an example non-IOT ESP32 sketch to test whether the board itself is still operating correctly.

If the board seems OK from the above test, then try starting over from scratch with a fresh copy of a minimal IOT sketch and see if that works. If it does, then your sketch may have had an error introduced.

If you have another board, try it too.

 

Good luck.


ReplyQuote