This is part of a bigger H0e model railway project ecplained in my blog https://tertittkameratene.blogspot.com/
I want to open two hinged doors operated by two SG90 servos. I want to use two MH sensor series IR sensors along a siding track leading to the doors to activate the opening and closing of the doors. I will also use an Arduino or Attiny85 to control the operation. Tomorrow I will add some pictures of the model arrangement to my blog. Now I have started to make a test on Tinkercad. I have connected a servo, a power source, an Arduino and an IR sensor.
My question is: how can I activate the IR sensor on Tinkercad?
Regards,
keknor
This is part of a bigger H0e model railway project ecplained in my blog https://tertittkameratene.blogspot.com/
I want to open two hinged doors operated by two SG90 servos. I want to use two MH sensor series IR sensors along a siding track leading to the doors to activate the opening and closing of the doors. I will also use an Arduino or Attiny85 to control the operation. Tomorrow I will add some pictures of the model arrangement to my blog. Now I have started to make a test on Tinkercad. I have connected a servo, a power source, an Arduino and an IR sensor.
My question is: how can I activate the IR sensor on Tinkercad?
Regards,
keknor
Hi @keknor, take a look at this video link:
.. it is an example of how to use the remote IR sensor in TinkerCad.
Good luck with your project!
regards, LouisR
LouisR