Farah Haddad
Farah Haddad
@fhaddad
Member
Joined: 2020-01-27 3:51 pm
Last seen: 2024-01-20 7:46 pm
Topics: 5 / Replies: 27
Reply
RE: Display 1088AS and Arduino Nano 33 IoT with LoRa

Hello, Ron. I apologize for any confusion I may have caused. I often feel behind in the forum, so I try to keep my responses concise. I'm sorry for ...

6 months ago
Forum
Reply
RE: Display 1088AS and Arduino Nano 33 IoT with LoRa

I figured it out; thanks a lot, guys.

6 months ago
Forum
Reply
RE: Display 1088AS and Arduino Nano 33 IoT with LoRa

@zander Ron can you please spot any mistake in my code below? // Include required libraries #include <SPI.h> #include <LoRa.h&...

6 months ago
Forum
Reply
RE: Getting Started but need some guidance on ESP32

@dronebot-workshop It worked fine thanks a lot Bill

6 months ago
Reply
RE: Antenna cable

@sysguru Yes please, just let me know what cable and what PCB connector I should use or are famous and widely used

4 years ago
Forum
Reply
RE: Antenna cable

Hi All, Thanks for your support. Let me update you on what happened with me perhaps you can help here. From the Antenna side, I had to solve the issu...

4 years ago
Forum
Reply
RE: Antenna cable

No one knows ?

4 years ago
Forum
Reply
RE: ATTiny85 with PIR sensor and two LED strips USB connectors

@dale So the result is amazing, I am now using it and all going well. Here's some photos

4 years ago
Forum
Reply
RE: ATTiny85 with PIR sensor and two LED strips USB connectors

@dale Oh yes I am so sorry I had to travel to the US for urgent meetings and I couldn’t do much I am going back home on Sunday so I will be able to ch...

4 years ago
Forum
Reply
RE: ATTiny85 with PIR sensor and two LED strips USB connectors

Hi All, I really don't want to bother you with my project cause it surly is a simple project for you all here but there is a fundamental problem and I...

4 years ago
Forum
Reply
RE: ATTiny85 with PIR sensor and two LED strips USB connectors

Thank you all for the support and the great information you've given me, the project is working fine and all is good. I am posting the project schemat...

4 years ago
Forum
Reply
RE: ATTiny85 with PIR sensor and two LED strips USB connectors

@casey No it’s not working, looks like the resistor 10k you’ve put between the gate and earth is a problem.

4 years ago
Forum
Reply
RE: ATTiny85 with PIR sensor and two LED strips USB connectors

@casey Thanks a million, though I was hoping to reach to the final solution without someone giving me the solution but thanks really appreciate it. Fo...

4 years ago
Forum
Reply
RE: ATTiny85 with PIR sensor and two LED strips USB connectors

ok I created this schematic and I have all the components, just want to know if I am going to burn anything before I wire it. Note the following: Pin ...

4 years ago
Forum
Reply
RE: ATTiny85 with PIR sensor and two LED strips USB connectors

This is really helpful I will Do the wiring on solder-less breadboard and will post the circuit schematic and let you know the result. I have a MOSFET...

4 years ago
Forum
Page 1 / 2