An '80s style robot I have unfinished
About two years ago I wanted to make an '80s style robot, similar but not a true clone if the Topo or BOB robots. These were made in the early to mid-'80s by Androbot. I always wanted one, along with every other bot made then 🙂
I have printed the head and most of the body. Here is the head:
The head is about 18 cm (7") wide and 15 cm tall (6") It has a separate plate that will hold two .96 OLED displays for eyes, a nose that will be a camera and neopixels for the mouth. The hole bot will stand @50cm (20")
I had to stop the project and most at the time due to getting another job. I may have to start it back up again.