Following is pic of Waterproof JSN-SR04T Ultrasonic Sensor I tested. Wire from sensor to electronics is 95" 2.4 meters @byron will follow up on ...

Posted by: @byron Thats correct. But of course we do not know about the quality of the code, the libraries used, etc, when we hear that an esp32 ha...

My perceived arrogance to you might well be based on your perception of events based on your own projections of issues within yourself. I say this in ...

Don't ever worry about asking a question that may have already been asked, this is a long thread and even myself and those who follow regularly forget...

Like I said in my last response to you, at this point my plate is over full. Never heard of Eclipse.

It does cost time and I would love to jump into testing it out but right now any available, and very limited, time will be spent learning my way arou...

I think this would make it difficult to fine tune where you want various water level to be detected.

I thought @byron was referring to a plastic version of clamp, correct me if I am wrong?

It is int the quality of the sketch but that it delivers clear information that counts. The information here is clear, thank you. In the pipe that I...

That is something to keep in mind just use these non contact sensors for upper and lower limits. Bit I am still feeling that one type of device with ...

Thx for the heads up on that ESP32 dependability. From what I think you are saying it seems that it not a hardware issue but a firmware issue where a...

30mm, exactly 28.18mm

@byron FYI A better way to flatten edge/side of 4" PVC FYI @frogandtoad @will Posted by: @wamagee Flattening the PVC was tricky, I screw...

I am migrating to PlatformIO as as I get more familiar with it will start looking into the interactive debugger. For sure it will better to first get ...

Non Contact Liquid Level Sensor, getting accurate readings from! Posted by: @byron FYI @frogandtoad @will Two thoughts, would they still work if...