The preview of the link doesn't work but here is the description: (6 Pack) Barrina LED T5 Integrated Single Fixture, 4FT, 2200lm, 6500K (Super ...

Hi Jim, Welcome to the forum. I am also in NW Florida. I am into about everything but learning a lot along the way. Just about finished my electro...

Thanks Will. So I guess the one with 3 resistors just adds one to the switch and would only be needed if/when the switch actuation would cause an issu...

@frogandtoad I was just curious as to why the resistors were there, but one seller uses 2 and one uses three. Anyhow, I looked at the datasheet and...

Well after some research I think I have decided I need to go with a centrifugal blower for best results as far as pushing air through a duct (pvc pipe...

@will I didn't realize dry ice was that readily available and inexpensive. WalMart even sells it. But I have air conditioning in my garage where I am ...

@will Too many hobbies . . . Not enough time. 😀 But so far I know, I will never be bored. You always read about people that retire and don't know what...

@will Too bad it's been taking so long to get to this point. If I just won the lottery I could air condition my big work shop. 😀

@will Hi Will, you are correct on the 3D printer drafts so that makes my fume extractor even easier to make. I found a 3x3x2 pvc hub and a 3x3x1-1/2 p...

I got my answer elsewhere but thought I would post it here in case it helps someone else. The Low Power version has a fixed current and is used for kn...

@will I already have some of those strips of LED's. Not sure if they are the ws2812b's though. 😀 They are single color. Thanks for the info and par...

@will Ok, sounds like a plan. With some sellers they list all the different ranges (part numbers) and the price is the same. But at a glance, ebay ...

@Myron I am really just starting with Fritzing but I found this to be a good beginner tutorial.

Thanks Will. Have a great day. I just bought a Kindle Version of an Arduino book so I can read it later. Take care.

Ok good info. I bought that bed leveling sensor from TH3D for the CR10S and have it installed but didn't test it yet. Added solid mounts (spacers) and...