Voltage
@voltage
Estimable Member
Joined: 2021-07-25 11:32 pm
Last seen: 2023-02-17 6:40 pm
Topics: 9 / Replies: 168
Reply
RE: DIY Solder Fume Extractor Questions

I know, I'm slow at things because I am working on too many things at all times. Then throw in some health surprises to slow me down a little and now ...

4 months ago
Reply
RE: Half a Million Subscribers - Thank You!

Congratulations! You have been working hard for a long time on this and it shows. Great job!

4 months ago
Reply
RE: Lighting for electronics work bench?

Followup pic on my LED lights. I added 4-4ft LED tubes and can switch them rear/front/both as necessary. Or I could just add the supplied jumper and j...

8 months ago
Reply
RE: Lighting for electronics work bench?

My upper shelf is the same size as the lower one and is for 3D Printers. Should hold 4 of them comfortably. And I have 4. 😋 I overbuilt this and it we...

8 months ago
Reply
RE: Lighting for electronics work bench?

I hear ya on the writing of checks but I like the paper trail. I have been hosed by a newspaper company with recurring monthly payments where they wer...

8 months ago
Reply
RE: Lighting for electronics work bench?

Did some reading. Interesting. Older eyes like mine definitely need good lighting but I seem to have more problems with shadows from blocking the ligh...

8 months ago
Reply
RE: Lighting for electronics work bench?

The preview of the link doesn't work but here is the description: (6 Pack) Barrina LED T5 Integrated Single Fixture, 4FT, 2200lm, 6500K (Super ...

8 months ago
Topic
Replies: 8
Views: 488
Reply
RE: Hello From NW Florida

Hi Jim, Welcome to the forum. I am also in NW Florida. I am into about everything but learning a lot along the way. Just about finished my electro...

8 months ago
Reply
RE: Question on EC11 rotary encoder breakout board resistors

Thanks Will. So I guess the one with 3 resistors just adds one to the switch and would only be needed if/when the switch actuation would cause an issu...

1 year ago
Reply
RE: Question on EC11 rotary encoder breakout board resistors

@frogandtoad I was just curious as to why the resistors were there, but one seller uses 2 and one uses three. Anyhow, I looked at the datasheet and...

1 year ago
Reply
RE: DIY Solder Fume Extractor Questions

Well after some research I think I have decided I need to go with a centrifugal blower for best results as far as pushing air through a duct (pvc pipe...

1 year ago
Reply
RE: DIY Solder Fume Extractor Questions

@will I didn't realize dry ice was that readily available and inexpensive. WalMart even sells it. But I have air conditioning in my garage where I am ...

1 year ago
Reply
RE: DIY Solder Fume Extractor Questions

@will Too many hobbies . . . Not enough time. 😀 But so far I know, I will never be bored. You always read about people that retire and don't know what...

1 year ago
Page 1 / 12