tentoes
tentoes
@tentoes
Member
Joined: 2020-01-29 10:29 am
Last seen: 2022-10-13 6:15 am
Topics: 7 / Replies: 21
Reply
RE: ESP32 CAM - 10 Dollar Camera for IoT Projects

A real improvement for these things would be for the maker (or supplier) to solder BOTH the jumpers for the internal AND external antennas. Then it w...

2 years ago
Forum
Reply
RE: Dual Band Mobile HAM radio question

@codecage Thank you, I understand.

3 years ago
Forum
Topic
Forum
Replies: 2
Views: 1814
Topic
Reply
RE: Soddering the wifi jumpers on ESP32 Cam

Hi so recently I ordered a few ESP32 Cam boards from AliExpress. Both of them have the correct resistor/jumper for using the external antenna. I hav...

4 years ago
Reply
RE: Soddering the wifi jumpers on ESP32 Cam

@dronebot-workshop The image I am referring to is one that I submitted, on that picture the resistor is visible. Sorry if I caused confusion...

4 years ago
Reply
RE: Soddering the wifi jumpers on ESP32 Cam

@dronebot-workshop Hi I believe if you look closely at the image, the existence and position of the 0-ohm resistor can be discerned and is proper fo...

4 years ago
Reply
RE: Soddering the wifi jumpers on ESP32 Cam

I don’t think I posted the second set of pictures properly so let me try again.... There, that’s better. If I was going to try to do this aga...

4 years ago
Reply
RE: Soddering the wifi jumpers on ESP32 Cam

Hi all so I have attached a pic of the reverse side of the module and another pic of the camera side of the module in the hope of providing something ...

4 years ago
Reply
RE: Soddering the wifi jumpers on ESP32 Cam

So I apologize everyone....I cannot find the information I used to order these. I am relatively sure that I ordered these from Ali Express and I am a...

4 years ago
Reply
RE: Soddering the wifi jumpers on ESP32 Cam

Hi yes I will.....I will get back to you.

4 years ago
Reply
RE: Soddering the wifi jumpers on ESP32 Cam

I have the same problem (when trying to “solder bridge” two contact pads together). My last attempt was trying to bridge two pads on an esp32 Cam mod...

4 years ago
Reply
RE: In Search of LM317 builds

Well the data sheet for the -317 should have a lot of typical, example circuits. I would start my search there. Good Luck

5 years ago
Reply
RE: What to do during lockdown??

Hi I am just learning about the programmable LEDs and controlling them with a Nano....

5 years ago
Page 1 / 2