@Inst-Tech I placed a couple boards to block access. All is well - didn't think they would jump/fly that far in the coop. All is well in Ohio. No...

Lesson Learned: Never place the control box within jumping/flying distance from the chicken's roosting bars. They will jump, roost on the box, and c...

@inst-tech Thank you. You're very kind. And yes, she's very happy that she doesn't have to worry about the devices being on or going out at nig...

Code: Each of the Arduino files are very large (approximately 1700 lines of code). I will paste them in a files so you can download. I would creat...

Nextion Display: I used three Nextion displays for this project. 1 NEXTION NX8048P070-011C-Y 7” Intelligent display (rabbit shack) 2 NEXTION NX8...

Hardware Pictures: The unit for each location are identical. Here are a few pictured of the unit for the rabbit shed: Before installation: Un...

@zander No problem. I wish you a speedy recovery.

@zander Can you send me the schematic and any design constraints (size, mounting holes, etc.)? If only 2 sided, and a smaller board, I am willing t...

I use KiCAD 6.0 to create the schematic, board layout and gerber files. Very easy to learn/do.

@zander Thanks Ron. I did some additional testing today and verified that the Serial2 port is working correctly. What I found is that when I include...

@zander ESP32-S3-DevKitC-1

@zander Ron, I think my problems are in my serial port assignments. The NEXTION libraries use Serial2 for nexSerial and Serial for dbSerial. Can you...

@zander Thanks Ron. I've been working with the S3 for a while and this is the first time I've seen that. I did verify the baud rates were the same.