Last seen: 2019-09-20 7:43 pm
You are completely correct. I will take your advice, just standard parts, cut to proper length, solder, heatshrink and be done. This is me telling y...
Pugwash, nice try & thanks. I am likely to follow Andreas Spiess -guy with swiss accent and purchase an Engineer PA-09 crimper tool and make what...
OK, just as robo-pi suspected based on earlier post: "exactly what I needed they'd probably be expensive anyway". While spyder's find is a low cost p...
Following up spyder's suggestion, 3dmodularsystems.com is in France so I will inquire about getting delivery to North America. I will send robo-pi's ...
@robo-pi Yes, as I replied to spyder, the sketch you offer is exactly what I was seeking. The sketch you provide is closer that what spyder offered a...
Hey spyder, this is what I am seeking, perhaps, 'splitter' or better yet, 'y connector' terms are what I could have called what I am looking for. You...
I have attached several photos with details. I don't see - I can't find - how to attach photos directly so this paste method seems to work. If you k...
Yes, I am completely aware of this connector you reference. But unfortunately, I am seeking male/female at BOTH ENDS. I am NOT seeking a male at one...