![triform triform](http://forum.dronebotworkshop.com/wp-content/uploads/wpforo/avatars/triform_503.png?lm=1714152079)
Last seen: 2023-03-21 4:56 pm
Thanks, @byron!
Sorry, no help from me then as I tend to use Node-Red mostly now. Others may have info here as well as the IoT section at/p>
We will need more data here :) What IoT service are you using? What are you trying to set up?
I have an updated Gerber for an RPI-Pico breakout board free for the making. It includes a place for an ESP-01 module, power for the Pico a...
@thrandell Unfortunately, this rarely happens :( The wheels almost always turn. For smaller bots, this usually makes it skew the current path...
@mike-za, I would try and source the control board outside the vendor. Unless it's some soviet made oddity from the cold war era, you should be able...
@huckohio The MD10C may not be grounded well. Is this seen on both controllers or just the one? A floating ground can cause induced noise and again,...
@huckohio It could be caused by a lot of things. Inductance, leakage, etc. Having a lot of wires running around, you can transfer or pickup voltage ...
@byron I think a pot would be a better choice here. Less stuff to do in the code. Just a map and constrain pair with the analog value.
Hi @peterpenpencil, I'm not sure if I understand what you really want, but this is what I have used on the RPI and Yun to stream with: ffmpeg Scot...
Hi @wolfgangw, I agree with the premise of the idea and have a set of sellers I try to use and recommend, but there are issues even with this many t...
Hi @mc2, How are you controlling the speaker? I would assume through a gpio pin, correct? If that's the case then you could use a PWM IO pin and ma...