Last seen: 2023-02-01 5:42 am
@thrandell The HC-05 will be for manual control as well as picking the different programs that the robot can run on an app. I actually just finished a...
@thrandell Here are a couple photos of the work in progress. I need to add the HC-05 module and do a bit more wiring on the shield for encoders and su...
@thrandell I'll be happy to post some photos. The course will be geared towards all ages with beginners in mind. I won't be using ROS in this tutorial...
@thrandell Hey Tom, my setup right now separates the Arduino itself from the 18650s (it runs on a 9V through the barrel jack). I am, however, powering...
@zander It is really rather small, It's on the bench at the moment in parts. I'm working on a course that will show wall following, maze-solving algor...
@zander Sorry, I should have mentioned that was the voltage I was going to run the motors on. I don't mind the 11.1VDC. JJ
@zander I guess I don't understand about the batteries, my 18650s seem to perform just fine in other projects I've used them in. Is there an issue run...
@thrandell I'm not really sure, I'd have to calculate it. Too fast for the unit though! I have the max speed toned down quite a bit (100 out of 255 I ...
@dronebot-workshop It's a 12V 3000mAh Matrix NiMH battery. I'm using two different buck converters for the components, one down to 5V and one to 3.3V....
@zander The Jetson is superior when it comes to visual imaging than the Pi and I plan on using a lot of OpenCV. Also, it was sooooo much easier to ins...
@zander ROS is Robot Operating System. It's hard to tell the cost, I've sort of collected the parts over the years. The base chassis is black acrylic ...