@thrandell Hi Tom! With the job and all the theater I do I haven't had much time to work on stuff over the past year and a half, and so much has chang...

@robotbuilder If you are going to use Raspberry Pi to run robots, definitely check out this course (wait until it goes on sale for $12 or so, it happe...

@thrandell The HC-05 will be for manual control as well as picking the different programs that the robot can run on an app. I actually just finished a...

@thrandell Here are a couple photos of the work in progress. I need to add the HC-05 module and do a bit more wiring on the shield for encoders and su...

@thrandell I'll be happy to post some photos. The course will be geared towards all ages with beginners in mind. I won't be using ROS in this tutorial...

@thrandell Hey Tom, my setup right now separates the Arduino itself from the 18650s (it runs on a 9V through the barrel jack). I am, however, powering...

@zander It is really rather small, It's on the bench at the moment in parts. I'm working on a course that will show wall following, maze-solving algor...

@zander Sorry, I should have mentioned that was the voltage I was going to run the motors on. I don't mind the 11.1VDC. JJ

@zander I guess I don't understand about the batteries, my 18650s seem to perform just fine in other projects I've used them in. Is there an issue run...

@thrandell I'm not really sure, I'd have to calculate it. Too fast for the unit though! I have the max speed toned down quite a bit (100 out of 255 I ...