Last seen: 2023-03-21 4:56 pm
Hello Ganesan, Welcome! I hope you enjoy the place as much as we do! Scott
Fit in the 2.54mm female headers? For that, I some times use male 2.54mm break-offs and do the same HS job. Some of the ones pictured are that way.
The new Naan boards are in! The latest to the Naan proto line: Both of these are single-sided and can be panelized at a small extra cost. I go...
hi @starnovice, I typically just solder the pins on the wire and heat-shrink them, I have a crimper that's ok and works, but I find it fiddly to us...
@anthonydkay You will need to add a TTL contact activate in the ladder (if you have a TTL IO card) or tack another relay in parallel with the motor ...
Hi @anthonydkay, Can you elaborate on the 12v input signal you will have? What type of components is it? Typically Arduinos want 3-5v input on the...
@ruplicator Yes, you will want to either power that regulator off or pull the esp out of the circuit. It can be fiddly during development :(
@ruplicator 3.2v is within the range of 3.3v supply, but it's the current that the esp has an issue with. I know when the esp came out, I beat my h...
@ruplicator The ESP is really picky about power. You will need to have a good supply to it and don't use any power regulator on the ESP8266 boards ...
@raven1152 BTW, if you are in the USA, there is a good deal to be had on a NEW Meanwell PSU in closeouts. Let me know and I can send the info to you...
@raven1152 If it's just a bench PSU, then you just want to remember not to do "stupid PSU tricks" ;) We all do that though :) If you put a heatsi...
Hi @raven1152, When I did the build of my PSU with the DP30 module, I did it the opposite way. I wanted a typical bench PSU voltage/wattage range a...
@robo-pi No problem. I use and the . Tk has been used under the covers for a few decades now, hidden away from general site :) The Wiki will have...
@robo-pi line_cnt = int(txtBox_1_dict.index('end-1c').split('.')[0])Should do it.
@robo-pi Yeah, the number is line.char_ndx. It gives you a way to do more detailed line manipulation. The Tk Text widget is actually a great one t...