Last seen: 2023-03-21 4:56 pm
@ve1dx Very nice. It is nice to be able to make your own designs! I have been soldering for a long time and am just starting to use SMD more. I...
I never could get the doc's for the is500 to load :(. With Modbus, you are reading and writing to registers on the device. These registers should co...
Hi @madmisha, You would want one. Damage is cumulative and at some point, the LED will probably stop working before it's time. thanks.
@abuhafss See: Page 508 shows the comm methods. Modbus via RS-232 & 485 or the Can protocol. NOTE: The 232 and 485 are not TTL (digital) sig...
@abuhafss What kind of servo controller is it? Some are similar to stepper chopper drives and have a step and direction, so GPIO and PWM. Others hav...
Hi @billd01, I assume you are using the string class. See the substring method in the string class. Also, you may want to look at pullup resistor...
@dronebot-workshop, @cadcamman I have both the V1 and V2 Pixies. They are neat for the time they were made and the size, but yes they are very limit...
@m4krd4d I usually add a fuse for just over my total current needs. Say I have a PSU that will deliver 20amps. I use only 4amps in total, so I will ...
@bwchester It's been a long while since I looked at this :) There is a ratio you used to calculate the AC into the rectifier and the DC out. 1.4 or...
@bwchester, The bridge rectifier is causing a 2v or so drop from the internal diodes. Usually, you would want to use a film capacitor rated @ ...
I have been trying to get myself to use it for my 3d print designs, but get lazy and do it in Tinkercad. I have used it some for my CNC machine, as i...
@bill21 Since you are in the UK, I would try
You can :) The Naan boards are my play on the "bread" in breadboard. I just called them Naan boards, because I love Naan, though can not partake o...
Hi Ganesan, Here is a great page I found and remembered :) It gives some details on the motors, their ratings, and driving them. I will also w...