@zander reflow and rework is when replacing components on boards I believe, and I have not done any of that but I do use a few SMD components such as ...

@davee I use this stuff its really good I use it for all the SMD stuff I do on the layout. Cheers Phil

@inq I have yet to work out the safety system to avoid car crushing but I have seen a video on YouTube where another Arduino system is put in place as...

@inq Well that seems to have solved that issue! I think I need to keep all the wiring for the two units separated as there seems to be an interference...

@inq this is the choice I have from all the units I have.

@inq 0.82 / 0.83 is all I can get I have a few others they are as low as 0.79

@inq I have wired it all up as you said and twisted that pot as far as I dare going in a clockwise from above direction and the maximum voltage I can ...

@inq Right I will have another read through and get back to you. Cheers Phil

@inq 24vDC only from now on. No more 12 v shenanigans! Cheers Phil

@inq I know they are meant to only run between 24v and 48 volts I checked when the second motor finally arrived yesterday.

@inq Another video with both motors connected using 12v dc. Cheers Phil

@inq Should I be fiddling with the pot on the 4988 unit yet? Up till now its exactly as it came out of the package, I do have a spare one of these uni...

@inq Another video showing the results using a 12vDC brick. Cheers Phil

@inq lastest video.... hopefully showing what I am doing. Cheers Phil

@inq I have one motor connected up to the brick (24v) and if you start it with your fingers it will start to run, but so poorly that it keeps stopping...