strongheart
strongheart
@strongheart
Member
Joined: 2020-09-29 3:17 pm
Last seen: 2022-06-12 3:58 pm
Topics: 8 / Replies: 19
Topic
Replies: 0
Views: 780
Reply
RE: DIY jumper pins for breadboard

@zoolandermicroSolderable, but they may have a coating to keep them from rusting (they are not stainless steel like grandma's pins were). I dragged ...

4 years ago
Forum
Topic
Replies: 13
Views: 1757
Reply
RE: DIY jumper pins for breadboard

The heads are markable - color-coded or numbered - or happy little emogies.

4 years ago
Forum
Topic
Forum
Replies: 4
Views: 2324
Reply
RE: I built my own 555!

@wolfgangw I too am a newbie and will strive to forever keep that status- forever young in mind and spirit - always ready to wonder.

4 years ago
Reply
RE: I built my own 555!

About 30 years ago I had a little book with about 2 dozen very simple 555 timing projects.It seemed as though there was nothing you couldn't do with t...

4 years ago
Topic
Forum
Replies: 1
Views: 1609
Reply
RE: Hi an Introduction

@spyderTerms of service agreement:"No entity consisting of over 50% electronics parts may enter"

4 years ago
Reply
RE: Hi an Introduction

@dronebot-workshopThank you Bill for your work and for signing me in to Dronebot.Lafayette was more of a marvel to me back then, I only got to play w...

4 years ago
Reply
RE: Hi an Introduction

@spyder I too am in a state of confusion.I recently wiped out both hard drive (intentional -after backup), repartitioned for multi boot on one drive a...

4 years ago
Reply
~Steve~

Hello, Dronebot World! (I could have coded that in at least 8 different languages).I'm not a lawyer but I passed the bar enough times without going in...

4 years ago
Page 2 / 2