Last seen: 2024-01-22 8:09 pm
Thanks again, Ron. I calculated 670F to be about 377 C, so using 400C is ok. I live in Norway. Its late now . I try your measuring tips tomorrow. ...
Thank you all for god and quick replies. About the soldering on the perfboard. It may not look so neat. its my firsi try on a perfboard, but I have ...
After three years with renovating our house (no time for hubby) , I am back on this forum hoping to learn, get help and hopefully be able to help othe...
@zeferby This is interesting. But I have had no luck in trying to put the command into the sketch. I am afraid I am not so good at writing sketches ye...
Hello again. Now I have wired up a Nano board with an ON/ON swich in stead of a POT and adjusted the turn of the servo to -45/+45 deg. It works fine ...
@robo-pi Yes, and fortunately a small part has been saved and is now a preserved heritage railway/museum
@dronebot-workshop Here is an old documentary of the real railway a few years before it closed down in 1960
@dronebot-workshop Thank you for the answer. I will try it as soon as I get the ATtiny85 boards. I have a UNO board and uploaded the Servo h sketch to...