@zeferby Thank you I will try this code tomorrow

but in many code examples i have seen that for testing the joystick modules the the serial monitor continoues to show some values while the joystick ...

What is this Section or Where is it ?

So That means my Joystick shield is not Properly. Guess I have to move on to the single joystick module.

@frogandtoad Actually It only happens when the arduino is being powered by the usb port but when i supply the arduino from the driver's 5V it self it ...

Thank You It was Very Helpful

no They have to be the PWM motors Cause I was able to control them Using Potentiometers. Maybe there is some error inside the code or I guess I have t...

This is the Cope From HowtoMechatronics.com and as You said I did Put a debug But I think it is wrong cause I am not getting any Reading at the serial...

I tried the Howtomechatronics code for the motor control but the results are not as good as expected. Take a Look:-

Actually the motors that I am using are 12V 200 RPM Motors an on the Internet I read Somewhere they are called as the Geared BO Motors. by a Buck-Boos...

I used this Code too but motors are not even responding and like no data is being transmitted at all. Take a look:-

@casey I used the code in that post and motors are still running weirdly.Take a look Is it because of the motors the I am using here ? they are bo mo...

the serial port on my car side is not working I don't know why. I have a question, does the l298n bridge draws too much current from supply cause it...

so should i have to take a screenshot of the values in the COM port of each transmitter and Receiver ?