@casey No it’s not working, looks like the resistor 10k you’ve put between the gate and earth is a problem.

@casey Thanks a million, though I was hoping to reach to the final solution without someone giving me the solution but thanks really appreciate it. Fo...

ok I created this schematic and I have all the components, just want to know if I am going to burn anything before I wire it. Note the following: Pin ...

This is really helpful I will Do the wiring on solder-less breadboard and will post the circuit schematic and let you know the result. I have a MOSFET...

@casey The “it” refers to the power supply not the circuit

@casey Yes the “it” refers to the LED strip

@robo-pi That’s bad you can’t see the video I am just showing how the voltage drops to 3.6V when I connect the LEF strip and yes the LED works fine wh...

Ok I connected it to my power supply and something strange happened I am not sure if I am doing something wring, the voltage keeps dropping to 3.6V an...

@robo-pi @casey If I may ask again, I have a rechargeable battery which is 1.2V 2450 mAh, since the 9V battery is rated between 400 and 600 as you men...

@casey Thanks a million. I will check and wire it up tomorrow and let you know the results thank you so Much

@robo-pi Perfect thanks I will do as you said, I will plug and measure the current. To be honest this didn’t cross my mind (how stupid I am but learni...

@robo-pi Really!! I thought I am going to get so many comments about the mistakes I've done in the schematic....oh this is such a confidence boosting ...

@casey the files you can't read are on Fritzing but I posted the circuit as a photo. The problem is that I checked the website of the LED strip and it...

@casey Thanks but I already asked the question to myself and I know the answer and that’s why I read articles and watched videos and took courses on U...