Bob207
@bob207
Member
Joined: 2021-01-05 10:26 am
Last seen: 2023-10-17 4:38 pm
Topics: 4 / Replies: 12
Topic
Replies: 1
Views: 764
Reply
RE: Don't see anything on 192.168.4.1

Sorry about the delay in replying. My network was due for renewal at the end of December and I have been spending the last fortnight trying to negotia...

1 year ago
Reply
RE: Don't see anything on 192.168.4.1

Yes, I know very little about networks. If I go to settings/networks and internet I see nothing resembling "YourAP" which is what I see on the phone...

1 year ago
Reply
RE: Don't see anything on 192.168.4.1

I turned the ESP32 on again and connected my phone to the wifi signal. If I now go to the server on the phone (chrome) and enter 192.168.4.1 I can see...

1 year ago
Reply
RE: Don't see anything on 192.168.4.1

Thanks for so many replies Ron. I am just going to answer the one "lets review". When I read through my entry I can see that I have missed a part ...

1 year ago
Topic
Replies: 27
Views: 3117
Reply
RE: Introduction to ESP32 - Getting Started

@Ron Thanks for that. I am referring to the video that Bill made. I will start a new topic.

1 year ago
Forum
Reply
RE: Introduction to ESP32 - Getting Started

I am not sure if this is the place to put this but I have a question about the video. I have an ESP32 feather that looks to work ok. Following the i...

1 year ago
Forum
Reply
RE: connecting to the internet

Has anyone managed to be able to stream the picture into a web site? I can see the picture from the camera on my local ip address and I am trying to...

3 years ago
Forum
Topic
Replies: 0
Views: 685
Reply
RE: Cheap linear power supplies comparision

take a look at this. I have used one for many years without problems.

3 years ago
Reply
RE: Using Servo Motors with ESP32

The solution is to add the lines client.print( "<!DOCTYPE html>" );client.print( "<html lang=\"en\">" );client.print( "<head><...

3 years ago
Forum
Reply
3 years ago
Reply
RE: Using Servo Motors with ESP32

I started a post here and have been advised to move it to here. I am looking to enlarge the font on the web page when using the sketch WiFiAccessPoi...

3 years ago
Forum
Reply
RE: ESP32 WiFiAccessPoint sketch font is too small.

If I highlight part of this sentence, say, just the word lines and click on <> above, preview shows it puts the whole sentence in a code box and...

3 years ago
Page 1 / 2