Maybe we're wearing each other out... I see I'm two posts behind in this thread. You're a machine! 😊 Your brain works on this stuff like its...

Nah... sailboats and model airplanes. Ain't that special!? 😏 This was my assumption when I asked them the question. The senso...

I have the sensor currently working with no added components and the Vout connected to an analog to digital pin using their drawing from their datashe...

Ctrl-A, Ctrl-C, before Add Reply is your friend. The Clip-Board will store it just fine. If it fails, re-login and Ctrl-V in the editor. On a Mac, ...

OK... I downloaded the referenced TI document and started reading through it. It sounds exactly like what I need. This does both the scaling and shi...

Aside, It is very frustrating on the forum when I take hours to write a reply (arguable with life interruptions... pet the dog, kiss the wife and co...

@davee, Hi Dave, I was hoping you were still an active member. I knew you'd be thorough and gear it to my level. Yes, your drawing is what I h...

Thank you @davee, but I don't know of anyone (else) that has followed on using the steppers. If you are looking to do just a RC toy car. The...

Hi @andydowns, Yes, an impressive project and perfect for a dronebotworkshop project! Skipping Steps I failed to fully qualify my statement. ...

I don't know anything about blast gates. I did YT to see what they were. Anyway... I do know that steppers skip steps, so your limit switches are re...

I had the same question - If you are wanting closer to the 1.5A ability of your motors, I would suggest using the DRV8825 driver. It is pin compat...

Someone on the forum wanted a tutorial a while back to set up a Raspberry Pi headless. I simply provide a set of steps that is pretty strait forward ...