Last seen: 2022-05-14 6:58 pm
@byron Yes. I'd agree with you, if it took the two and a half hours to get to the undefined state. However, as seen below, it would have to complete t...
FAHC: 2 Hours, 28 Minutes, 34.206 Seconds đź‘Ť
@starnovice Yep. I agree. but only from a position of partial ignorance. I've posted to the Arduino forum, and am hoping for clarification.
There seems to be a lot of problems with loops posted on the Arduino Forum, but nothing that seems to match my issue. I continue to hunt. Oh and by ...
Once my 32 bit timing test completes, I'll run a build in verbose and see if there are any clues.
Thanks @sysguru, Just goes to show, there's always something to be learned. It's one of the reasons I'm in the forum đź‘Ť
Farah A closer look at the picture of the male connector, makes this a little more difficult. you'll see in the image below that the similar connector...
@pugwash Phil may be right. I read through a couple of posts and it seems that, although both have I2C interfaces, there is little support for running...
I found some SPI libraries on my Arduino IDE. Go into your Library Manager and search for ESP32DMASPI and for TsyDMASPI. Now I may see them because I...
Found this on SPI:
Shot in the dark here but... CAN BUS? Teensy has it built-in, and there are modules available that may work for the ESPs.
Have you looked into SPI? I am working on a multi-processor robot, utilizing a Raspberry Pi and three Arduino Nanos. I just got SPI comms running last...
@fhaddad Glad to hear everything worked out for you.
@fhaddad No problem. I am just interested in the outcome.