Welcome to the forum. I would like to know more about how exactly do you apply microelectronics to your rocket system. I hope you have a nice time...

Welcome to the forum!

@xenophon Congratulations!

@inst-tech Thank you for your suggestion. I've made my decision: it's probably going to be IR as the point of this robot is not really to work over ...

@zander @inst-tech @davee I attached some plastic sticky tape on the tips of the robot's legs, and its speed has increased sixfold! Unfortunately...

@inst-tech @davee @zander After some extra tweaking, the robot now moves a bit faster and is more steady. Here is a picture of it (I cannot send a...

@zander @davee @inst-tech Today the robot moved its first steps. It is very slow because it doesn't have a lot of traction on the floor, but it mo...

@davee Many thanks for your suggestions. A small note however: I'm powering this project with NiMH batteries rather than lithium for safety reasons....

@will @zander I've just discovered that all components, including the Arduino, are intact. The only slight issues are the battery wires' silicone ...

@will @zander I will probably just solder the wires to the PCA9685 instead.

@zander @will @inq @byron Today the connectors finally arrived. After I soldered them, I moved on to testing the movement code. Unfortounately, ...

@byron @will @inq Hello again, I have an update on this project Today all the required components arrived. Unfortunately I ended up soldering th...

Welcome to the forum!

@inq Thanks for your kind words

@byron Thank you for your suggestions. The robot will follow a fixed pattern, it will no be remote controlled. Therefore, I don't think it needs t...