@zander I have done my calculation and at that point you can get from250 to 1Kg. It is out of the way and not impairing the feeding of the read when y...

@zander Not sure if it would. That's is why I'm asking. I was under he impression the Arduino would not do this task. Was looking at esp32 and and. I ...

@inst-tech Was thinking of using a STM 32 Nucleo. It can multi task. Do any one know of this processor?

This is not even close to a commercial project. I think most of you here will have a good laugh if you see my setup. The red x is where the load cell ...

Maybe Bill must do a basic coding course. The way he presents his videos are great for me. If he had the time to do so. Not sure. Thanks to every o...

@rob42101 Please send me what you think will help. I was looking at python but like you say there are so much. C++ s another one but same story.

@zander Sorry for asking. Did not know. I'm just at the end of my line. I can not wait 2-5 years to make this work. I will have to look for something ...

@zander LOL And here I was thinking I'm getting the hang of it. I'm sitting here all off my spare time trying to learn and I have noting to show. Is a...

@will The pot will give the UNO a reading in volts. That is how the UNO set the speed. 0V to 5V = 0 to 255. That is my thought? The volts to the stepp...

The load cell works perfectly but the stepper turns 1 rotation every hour. lol. I'm getting a reading of 14 on A0 pin thru the serial monitor. That is...

I have tried and can not get it to work. It wont compile. I have added the Millis to it but still no go. #include<FlexyStepper.h> #inc...

@inst-tech I keep getting this error. Compilation error: no matching function for call to 'HX711::HX711()'

@inst-tech Thanks for helping. I will try it again and go back to the first post to read them again.

@zander I have done it separate. Then everything works. The load cell prints to the serial monitor. Not sure how to get the reading to the potentiomet...