Last seen: 2024-05-02 10:53 am
The following worked for me. int buttonpin=2;int led1 = 7;int led2=8;int delaytime=2000;int lastled; void setup() {pinMode(buttonpin,INPUT_PULLUP)...
There are probably voltage drops over the wires leading from the psu to the various destinations. Try using thicker wires for the power leads. M...
@revver11 My very thoughts. I would be ivery interested to follow such a project. hj
I do not have much experience with lidar but I suggest you try putting " lidar.begin(Serial);" after the " Serial.begin(115200);" Just a thoug...
Nice build. Thanks for sharing.
Nice!
Good design.
glad to have helped.
OK Right after 'void loop() there should be the opening brace, like this '{' Just add it on after void loop() and it will compile!
It is probably a typo before the 'if' statement. I am just guessing, as I do not see the relevant code.
you need to specify the type of currentStateCLK before using it. something like: Int currentStateCLK;
Try printing out the analog read values with more decimal points. the difference may be due to the mere 10 bits resolution of the ADC. Hope this help...
@frogandtoad STM32 could probbably also be a good candidate. I think that for real fine control stepper motors are required. It would be interesting t...
@frogandtoad STM32 could probbably also be a good candidate. I think that for real fine control stepper motors are required. It would be interesting t...
Enjoy! hj