IanNS
@ianns
Member
Joined: 2021-01-17 11:50 am
Last seen: 2023-04-29 9:37 am
Topics: 1 / Replies: 17
Reply
RE: Help with code please

@zander Any of the many solar tracking videos on youtube is what I meant.

2 years ago
Forum
Reply
RE: Help with code please

@will I think to be honest the only videos worth watching are the ones Bill posts. Some of the others are a waste of everybody's time.

2 years ago
Forum
Reply
RE: Help with code please

@zander No 5A It did everything it should after the 3 stage set up procedure.

2 years ago
Forum
Reply
RE: Help with code please

@zander I am using A 5 A Mppt I am impressed with it

2 years ago
Forum
Reply
RE: Help with code please

@will It started towards the sun then would move to the west then back & forth. I moved the sensors much closer together and had a good barrier ...

2 years ago
Forum
Reply
RE: Help with code please

@zander I had the battery & I did not like what I was reading about charging Lipo's in extreme cold

2 years ago
Forum
Reply
RE: Help with code please

@zander My consumption is very low ESP8266 & AM2302 sensor. I have tried my clamp-on ammeter, got nothing & wired in a power meter and too l...

2 years ago
Forum
Reply
RE: Help with code please

I have dismantled it, it worked well on the bench but not in sunlight Thank you everybody that helped Ian

2 years ago
Forum
Reply
RE: Help with code please

@zander Elmsdale, Nova Scotia Just a 10w panel keeping a lead acid battery charged to run a basic IoT weather station.

2 years ago
Forum
Reply
RE: Help with code please

@zander I am ready to give up it is still rocking backwards & forwards. I believe here in Nova Scotia there is something to be gained by moving ...

2 years ago
Forum
Reply
RE: Help with code please

@inq I will move the sensors today, going forward I may direct drive the pivot shaft the same as Jessica did. At the minute I am lifting the panel as ...

2 years ago
Forum
Reply
2 years ago
Forum
Reply
RE: Help with code please

@will I agree, they are a least 300mm apart.

2 years ago
Forum
Reply
RE: Help with code please

@inq I was limiting my start & finish position, have I done wrong?

2 years ago
Forum
Reply
RE: Help with code please

@inq Mine is slightly different, the lady that wrote the code had her ldr's mounted on the panel centre line of the pivot with a divider in between. ...

2 years ago
Forum
Page 1 / 2