Notifications
Clear all
Show & Tell
1
Posts
1
Users
0
Likes
1,148
Views
Topic starter
2019-09-30 1:47 am
The claw is over all from base to top 9 in the slide compartment that houses each individual claw is 6 inches wide by 2 1/4 inches high by 3/8 deep the box that houses the 2 servos is 3 1/4 inches wide by 2 1/4 inches high hand made of course but I'm sure it can be three d printed the retractors are a blown up version of the one bill made hand made the circle s have to be opposite from one another for them to work together