Witchdoc59
@witchdoc59
Eminent Member
Joined: 2022-11-20 10:48 am
Last seen: 2023-11-11 4:55 am
Topics: 6 / Replies: 14
Reply
RE: Connectors

@inst-tech Wow, that's the best datasheet I've seen for this module. Thanks.

3 weeks ago
Reply
RE: Connectors

Thanks everyone for all the comments and suggestions. I've ordered some 1.25 from Amazon and I'll study that website closer. The connector is for a ...

4 weeks ago
Reply
RE: Connectors

This might be a more useful photo of the one I'm looking for.

4 weeks ago
Topic
4 weeks ago
Replies: 15
Views: 245
Reply
RE: Topic Suggestion: Connectors!

Did this video ever get made? If so what was it called? I'd love this.

4 weeks ago
Reply
RE: GPS Antenna

@zander There is the backside. I'll hook it up to the computer and see if it's receiving anything but I thought I'd need the screw on antenna.

1 month ago
Reply
RE: GPS Antenna

@zander here is the picture of what I received. And yes I've watched Bill's video a couple of times. I've also been playing with a Beitien 880 ...

1 month ago
Topic
1 month ago
Replies: 11
Views: 109
Reply
RE: What are these?

The board to the lower left says, Ver:1.1 at the top and at the bottom it says, SSOP4-28Pin 0.65MM. The board pictured above that one says, SOP20Pin...

8 months ago
Topic
8 months ago
Replies: 5
Views: 302
Reply
RE: GPS Modules with Arduino and Raspberry Pi

@zander Hi there; I managed to get it all working. At line 108 there is a delay(). It seemed to be that area where the sketch was failing. So I comme...

11 months ago
Forum
Reply
RE: GPS Modules with Arduino and Raspberry Pi

@zander Thankyou very much for your attention to this. I appreciate it very much. The duplicate 'include' is a mistake that I thought I had fixed. ...

11 months ago
Forum
Reply
RE: GPS Modules with Arduino and Raspberry Pi

Here is the script with the magnetometer code added in. I believe I used Bill's magnetometer code. Everything up to about line 112 works then not...

11 months ago
Forum
Reply
RE: GPS Modules with Arduino and Raspberry Pi

Here's my working GPS it displays the time, lat, long and altitude on a 4 line lcd #include <Wire.h> #include <LiquidCrystal_I2C.h> ...

11 months ago
Forum
Reply
RE: GPS Modules with Arduino and Raspberry Pi

I went and bought a BN880 and I’m wondering if it’s possible to run both the magnetometer and the gps at the same time. I’ve got a working gps sketch ...

11 months ago
Forum
Page 1 / 2