I tried Run() and it just takes off and doesnt stop until i turn off the power. The acceleration was originally at 2000 but it wasnt working and i kep...

The acceleration isn't working, that the problem I am having with the code. RunSpeedToPosition is the only function that does not block but doesnt use...

All I want is for the motor to act like a regular motor in that it moves my mill table back and forth so I am not constantly cranking the wheel by han...

@will Ya, I'm new here and I didn't write the sketch. I did figure it out though. Thanks

Cunningham was right

10th post

9th post

8th post

That looks good to me. I was planning on using a terminal screw strip so that works. The LED and hall effect are going to be remote mounted. As for di...

@mark-bolton Not a problem, hope you feel better soon.

@mark-bolton OI, mind moving this conversation to a different topic, I need help and this has nothing to do with it, thanks