Last seen: 2023-03-21 2:04 am
@davee I have a couple of IR Sensor transmitter kits with a both a transmitter and receiver. I think they are meant for tv remotes and the like bu...
Thanks for all the responses. To address as best I recall; The reason for 2 gates is to control the flow of the balls, which i will now accomplish b...
@will I like this idea. I think the simplest solution for the multiple ball problem is to move the gates closer together. So between the two gate...
@davee Thanks for the reply. At this point I am just trying to get the sensor to detect a ball, open gate 1 for 350ms, then close the gate. The...
@zander In the example codes I had found for use with this sensor no additional libraries were included.
@zander I like the idea of a microswitch instead of the IR sensor, as the application would be similar, however, the ID of the tube is 1.75" whic...
@zander The part number for the sensor is: E18-D80NK IR The 350ms delay on the servo is necessary to only allow one ball to pass. I could incr...
@davee Wow, thank you for the thorough looking through. My instincts tell me you are correct. My initial calibration setup was pretty hacked togethe...
Thanks for all the replies! I have included the code I am using below; note it is directly taken from the DroneBot tutorial on the color sensors wit...