@tfmccarthy I'm good. Thanks!

@tfmccarthy, my "solution" was to revert from the current ESP32 core v3.3.0 to the previous version v3.2.1. That resolved the errors, and at some poin...

@tfmccarthy Thanks for the reply. FWIW, I did search the form as well as Googling the issue. There was lots of advice, but none seemed to work for me....

My solution was simple in the end. After spending too many hours searching for a solution, I uninstalled version 3.3 of the Arduino ESP32 core and rev...

@inst-tech and frogandtoad, thanks for the suggestions. The article on proximity sensors was very helpful. SP

@inst-tech Along those same lines in woodturning we say, "Never take that last cut." Why? Because that's always the cut when you go through the side o...

@zander Thanks for the info on the remote control for the video camera. I will definitely keep it in mind. If we were to have to pick on of the axis t...

@zander Oops, forgot. I'm using an Expressiff ESP32 board with WIFI. I'm planning on using ESPNOW to communicate. Seems to work well over the short di...

@zander Some of the VIXIA models do have Canon Connect I see, but ours are fairly old. I would have to get the specific model and look it up. If they ...

@zander I haven't seen anything about special macros. Can you point me to something about them?

@inst-tech Thanks for the info. It helps a lot to get advice from people like you and others here that have been in a particular specialty and have re...

@zander Not built into the camera, but I have a solution for that too thanks to YouTube. 😀 😀 😀 It is basically a metal bracket that fits around the...

@zander It's much the same in the US. We have an international woodturners organization and they require shields at all of their sponsored events and ...