Papymouzot
Papymouzot
@papymouzot
Eminent Member
Joined: 2022-07-25 10:49 am
Last seen: 2022-09-20 3:59 pm
Topics: 2 / Replies: 22
Reply
RE: Implementing a safe unlock application

We havent discussed about this, I was extremely lucky when the original electronic board which sits inside the safe's door became faulty, I retrieved ...

4 months ago
Forum
Reply
RE: Implementing a safe unlock application

Hello from the South of France, where it is still too hot and no rain... I start to feel a bit better today, thanks god ! Yesterday I worked on my...

4 months ago
Forum
Reply
RE: Implementing a safe unlock application

Thank you Ron, my visage is healing quite well, the worst thin is that I have terrible headaches which prevent me to do anything

5 months ago
Forum
Reply
RE: Implementing a safe unlock application

Back from the hospital, another few weeks and I'll be like new :)

5 months ago
Forum
Reply
RE: Implementing a safe unlock application

Thanks Inq, I tend to recover quickly normally, I never had such bad injuries on my face to date however... I will endup with a few scares for sure....

5 months ago
Forum
Reply
RE: Implementing a safe unlock application

Hello, I left you without news for a few days, I had a mountain bike accident and I just left the hospital yesterday... I look like if I hit a train i...

5 months ago
Forum
Reply
RE: Implementing a safe unlock application

Hello, where are you guys based, I thought you were in the USA and with a nice time zone difference… ??? 😅 today I manage to have the deep sleep wor...

6 months ago
Forum
Reply
RE: Implementing a safe unlock application

Thank you Ron, I will definitely look at the links you just mentioned. I probably missed them first. Thanks a lot for your help, ideas and advice. ...

6 months ago
Forum
Reply
RE: Implementing a safe unlock application

Hi Ron, I could not find deep sleep tutorials for Mega328P based Arduino pcb's on this web site. I however have seen on their web site some tutori...

6 months ago
Forum
Reply
RE: Implementing a safe unlock application

Here is my tiny test jig with a small test keypad, a 5V buzzer, led and relay. On the top right the Battery I was thinking about using. 3.2-3.3V

6 months ago
Forum
Reply
RE: Implementing a safe unlock application

I forgot to say: my test jig uses 1,4mA when in deep sleep mode, without change to the HW, so with the PWR led still on. with 2.5Ah cell it only giv...

6 months ago
Forum
Reply
RE: Implementing a safe unlock application

Hello, some news from the south... I received one of the boards I ordered, a pro mini 5V... Although I read somewhere it was an ultra low power boa...

6 months ago
Forum
Reply
RE: Implementing a safe unlock application

Hello, I have spent more time on this and I still have issues… My code works fine without sleep mode and still uses 10mA on a 3.3v lifepo4 cell whic...

6 months ago
Forum
Reply
RE: A new Arduino beginner from the South of France

Thanks Ron, I will probably have more projects in the very near future, I have succeeded to nearly complete one of them, however I still have issues...

6 months ago
Reply
RE: Implementing a safe unlock application

Yes, but this doc isn’t about the Atmel328 family, it is for the samd21 boards…. 😕 😕

6 months ago
Forum
Page 1 / 2