olddude
@olddude
Member
Joined: 2022-09-22 4:04 pm
Last seen: 2022-09-26 8:51 pm
Topics: 1 / Replies: 25
Reply
RE: Hello from Reno NV.

@inq Thank you so much. I really appreciate your input. Regards, Jim

2 years ago
Reply
RE: Hello from Reno NV.

@inq Yes, i just got back from the machine shop to do that very thing. They are working on getting the gears needed to solve my problem. I am still ...

2 years ago
Reply
RE: Hello from Reno NV.

@inq yes even with that high of a percentage it wouldn't hold up. I run at 4,000 rph. in an 8 hour day 32,000 revs. That equates to a rather large...

2 years ago
Reply
RE: Hello from Reno NV.

@inq Wow that is pretty close. I have to work out what would happen in an 8 hour day. Thank you.

2 years ago
Reply
RE: Hello from Reno NV.

@inq Sorry for the slow response. I was in town on a business issue. I have a stepperonline nema 17 CE ROHS 17HS19-2004S1

2 years ago
Reply
RE: Hello from Reno NV.

@will Got it and thank you. Problem solved. Jim

2 years ago
Reply
RE: Hello from Reno NV.

@inq Thank you for your input. I have hit a problem with this and that is that the stepper cannot do exactly 60 degrees, but comes up short at 59.4....

2 years ago
Reply
RE: Hello from Reno NV.

@will Thank you for your note. It is a problem being at 59.4. As my unit will have to rotate 8 hours a day my unit cannot be off by any degree. So ...

2 years ago
Reply
RE: Hello from Reno NV.

@ronbentley1 Ron I just got a message and it caused me to be concerned. It appears that my requirement of 60 degrees is not possible due to the ra...

2 years ago
Reply
RE: Hello from Reno NV.

@will Thank you so much. i have been worried that I was not going to be able to solve my problem. Again, thank you.

2 years ago
Topic
Replies: 55
Views: 1964
Page 2 / 2