@codecage Screenshot attached of warning in the cytron MDD10A rev.2 manual hope this helps! Mel.

Hi Paul, Watch Paul McWhorter's YouTube video series on the elegoo car build. A step by step build of the car and then programming from scratch! ...

Hi Tom, Not yet unfortunately, due to a few family issues recently. I’m on vacation for a week now, but will be away from home, so will not have cha...

Thanks Tom, I will take a better look later this week when I get off work 👍

Thanks Tom, yes, that would interest me greatly! Have based most of the control so far on Brian’s code, see the Henry IX post, but all input is gl...

Also watch this YouTube video for further info on hot wire cutter. regards

@GBH168 I have attached the wiring schematic for my bench power ATX conversion. hope this helps! Regards from the Midlands, Mel. *currently ...

@rimshot609 i would always look to connect the live/positive power connection last. That is why most power switches are fitted on the live supply. ...

Surely you would wire and test the circuit before connecting the power supply? if that is what you have done and the spark happened as you connected...

Pdf from Bills GitHub folder for the motor control board I have built. @robotBuilder 😊 😊

@robotbuilderI'm thinking of adding a servo and extra sensor on the front of BB1, as I have both available. This I would connect directly to the Meg...

Good morning guys, All very interesting reading! Does this mean my static ultrasonic sensors are not the way to go? I have 8 on the four base co...

@robotbuilder yes 16 ultrasonics with RGB LED’s signifying green for good, blue for getting close and red for stop. the circuit board at the rear ...

Photo didn’t attach to reply🙄