Last seen: 2023-09-28 6:52 pm
Ok, I will get that the next time I work with those. Although, I would just prefer to buy a new one that has it built in. It's not like the size diffe...
It does not get that far. The com port is not showing up in the IDE because windows is throwing the error and is putting it into a different category....
@zander Different manufacturers use different chips. ESP32Cams seem to come with the FTDI chip instead. I do in fact have the CP210x but I was desp...
To be fair, there are prebuilt controllers that plug right in and do all this stuff for you. Power included. But where's the fun in that!
@huckohio In the Factory Firmware folder there is an image. I would copy that. I know you can put different .bin files to different locations a...
@will So is that the forward current? I guess an LED is a diode after all, I just never/never needed to think about that with regular diodes. Or...
@will I will be using wires to get from the control box to the strip. I would have to cut one off the end that I am not using(the leftovers) and st...
@will Yes, exactly. The only problem with it is that I would have to strip away part of the coating the gives the strip its IP rating. Having done ...
@will Yes, it's the control pin that I am concerned about. I was initially going to run it direct and see what happens but once I install it under ...
@will The issue is that the controller is 3.3 logic and the LEDs need 5v. I need to step up the logic from 3v to 5v.
I have reuploaded/updated LuaNode32 before. Your not loading the INO files. I would assume that when it compiles, it will include those INO files in t...
A LED can send more Volts than it receives. Sure. The IC detects high/low signal based off of its supply voltage and then retransmits the mess...
Ok, so I read that most 5050 LEDs have issues with 3v logic. There seems to be a trick of feeding the first LED a slightly reduced voltage but in betw...
LEDs are here. Positives and negatives are all connected to each other. It looks like they are just simple bus bars. I will try and run it off of 3 vo...