so i try to upload this.. i think its commenting out all the sd functions...and i get this error message from compiler C:\Users\VanillaGuerilla\...

/* GPS Position Logger gps-position-logger.ino Read GPS data from BN-220 or any serial GPS sensor Requires TinyGPS++ Library Save to SD...

i did go back to the raw dronebot version of the code

after this i still get the same output from the serial monitor im hooked up to all the same pins as before.... and im getting a blinking light fr...

/* GPS Position Logger gps-position-logger.ino Read GPS data from BN-220 or any serial GPS sensor Requires TinyGPS++ Library Save to SD...

sorry im not very good at this forum and gadget stuff... i get like 2 hr a day tops to get on the computer because im a knuckle dragger... my nano is ...

so now i cant upload to my nanop for some reason.... my original question is trying to get this to run on an esp8266 or esp-12e.... any help on that f...

thats cute.... but im telling you when i try to upload the code it says there is 30k avail andtheres not enough room.,.. its not an actual arduino its...

because theres only like 30k available on the nano

Theres not enough memory on the nano.... tried a few different librearies to no success

ive already gotten some successful results from the gps using an arduino uno.... i wanted to use a nano but the code and libraries wont fit... im tryi...

wasnt sure about the LED's being compatible so i just disabled all the led blinks. i get this from the serial monitor after i upload to esp12-e: et...

ok here's an improved version of my code /* GPS Position Logger gps-position-logger.ino Read GPS data from BN-220 or any serial GPS...

Muh bad ill give this a whirl [code] /* GPS Position Logger gps-position-logger.ino Read GPS data from BN-220 or any serial GPS sensor R...