Kirk
Kirk
@kirk
Eminent Member
Joined: 2021-10-10 3:31 pm
Last seen: 2022-10-05 11:37 pm
Topics: 0 / Replies: 26
Reply
RE: Arduino based function to control stepper motors

@zander @Inq Hi Ron, I located the problem, aka my mistake. I had switched between a couple of different types of driver boards and assum...

3 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@zander Re: Arduino cables. What I intended to be ordering was two male/female cables 4 strand x 50 cm. They are on their way. You may be right I d...

3 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@zander For anyone interested I found a source for cables with Arduino terminals on EBAY. I pasted the link below.

3 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@robotbuilder Hi, The code is designed to turn the motor-that was the plan anyway.

3 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@zander I appreciate the good advice. I will update you on progress.

3 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@zander Thanks Ron. I will compare sites and see what looks good.

3 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@Inq At this point I think the problem is wiring but I did order another Arduino Uno just for comparison. My project led me to create an intermediar...

3 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@Inq I have tried your program and used it with a new motor of the same type and new driver board of the same type. I still have no rotation. I re...

3 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@will @Inq I updated the code to use a constant of 100 for StepsRequired in the Constants section and both functions (Stepper 1A and Stepper...

4 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@inq Thanks for all of your patience and assistance. I reviewed your suggestions and will make changes accordingly. Hopefully I will have the motor...

4 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

Inq: In response to the three comments you made: 1. In Setup I inserted the intStepsRequired because I thought all the variables had to be...

4 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

Inq, Thank you for your assistance. I have placed an updated version of the code below. Hopefully the replacement parts will arrive tomorrow. ...

4 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@will Motor Test_M3_72522 [code] // Motor Test_M3_72522 //compiled: 7/24/22 Tests:7/24/22 with M3+ ->ok,7/25 M3- --&...

4 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@will Motor Test_M3_72522 [code] // Motor Test_M3_72522 //compiled: 7/24/22 Tests:7/24/22 with M3+ ->ok,7/25 M3- -->...

4 months ago
Forum
Reply
RE: Arduino based function to control stepper motors

@inq Hi thanks for your advice. I reposted my sketch as a reply to Will's first comment and formatted it. I have ordered another driver and stepp...

4 months ago
Forum
Page 1 / 2