It's been a while! But it's a thing! It has not done all the things I wanted it to do, but quite a few of the things work in the end. Have a peek he...

Cheap continuous servos are, as far as I know and as far as I've seen them used, just normal geared down motors in servo motor form factors and do not...

Thanks for your reply @inq ! Don't worry, I think you're grossly overestimating the complexity of this project. This robot does not need to do even ...

Yeah, it will definitely rotate both ways, but I've calculated that some high strength loctite may support the connection just about good enough.

Yes, I'm considering that too. I've never worked with axis couplings, but without adding a key to them (as I don't have the tools to create a slot for...

Another question, any suggestions on how to couple a shaft to it? I need a shaft of about 70mm on the end. I was thinking of drilling a hole in a sh...

Thank you both for your replies! I had a look at the local scrapyard, but they cost about as much as new ones here even if I remove them myself, and...

Hi guys, thanks for the warm welcome! Yes, I'm familiar with James Bruton's channel, I certainly look closely at it for inspiration! As for my age...