Last seen: 2021-07-30 7:13 am
I am not sure that I said that all the gates were open. Perhaps more detail is required. I am using the panel saw and the gate is open. I finish and...
Thanks Steve. I am new to Arduino and electronics in general. I want to put the gates in areas that will be hard to access, under benches and shelve...
Sorry about the delay, but I lost a hard disk so no computer for a while. Do NOT TRUST Windows backup except for files that you don't want! Thanks f...
I am not sure how to code a push switch to start the close procedure.
My current plan is to have a keypad at each machine. When a key is pressed broadcast a signal to all gates to close, at the local gate open servo on p...
Yep, not 100 gates. Not sure about the current sensor as half the machines are 15 amp on 240v. Also one the gates will connect to portable machines on...
Thanks.