DavidL
@davidl
Member
Joined: 2022-06-06 10:18 am
Last seen: 2024-01-02 5:53 pm
Topics: 8 / Replies: 31
Reply
RE: Breadboard power supply decreasing voltage

Ron, Could you recommend a specific meter or brand? I searched for multimeters with clamp on ability, and the prices ranged from about $30 to over ...

2 years ago
Reply
RE: Breadboard power supply decreasing voltage

It was the batteries! I tried two and thought that was enough. Next time I'll try three. The two batteries that I was using initially were from ...

2 years ago
Reply
RE: Breadboard power supply decreasing voltage

Ron, thanks for the response. I'm going to get new batteries later today. The batteries I tried were unused, but they could be years old. I'm also ...

2 years ago
Reply
RE: Breadboard power supply decreasing voltage

Hi Dave, Thanks for the help. The power supplies are "HiLetgo", not sure if that is the type you're describing or if that's enough information. H...

2 years ago
Reply
RE: Breadboard power supply decreasing voltage

Hi Ron, thanks for the response. It's good to know that I should be seeing steady voltage. I should have mentioned that I've tried with two batte...

2 years ago
Reply
RE: esp32 cam corrupt image

I think I just had a bad camera. I had ordered two units, so I replaced the camera with the camera from the second esp32 and it worked fine.

2 years ago
Reply
RE: ESP32 voltage regulator

@zander, Thanks again! I'll be prepared for a failed compile. It's going to be a while before I get to that point, but I will contact you when I'm t...

2 years ago
Reply
RE: ESP32 voltage regulator

@zander, Thanks for the help. Your explanation about how the internal voltage regulator is used is very helpful. I will use an external voltage regu...

2 years ago
Reply
RE: Soldering leads to DC motors

@davee Hi, I agree, the advice has been terrific. It's great to get so many responses! Thanks for the information about the Amazon URLs. I'll keep...

2 years ago
Reply
RE: Soldering leads to DC motors

@fritigern Hi, Fritigern. Thank you for the response. I will keep in mind the advice about cleaning the components. I haven't cleaned anything (may...

2 years ago
Reply
RE: Soldering leads to DC motors

@inst-tech Hi LouisR, thanks for the advice. I think I'm going to look for a soldering station sooner rather than later. I appreciate the detailed t...

2 years ago
Reply
RE: Soldering leads to DC motors

@davee Thanks for letting me know about the link. It looks like I added a couple of characters. It was supposed to be this: I'm sure it's a pre...

2 years ago
Reply
RE: Soldering leads to DC motors

@inq Thanks for the suggestions! I will probably get a soldering station, and I'll definitely look for solder with the characteristics you recommende...

2 years ago
Reply
RE: Soldering leads to DC motors

@inq Thanks for the pointer! Can you recommend a brand? I just bought some that doesn't seem to have any silver. Fortunately it's cheap, so I can ...

2 years ago
Reply
RE: Hi From DavidL

@sj_h1 Hi sj_h1, thanks for the welcome! I'm looking forward to being retired in about 9 years and 9 months (I'm counting the days).

2 years ago
Page 2 / 3