Yeah, unfortunately the motorized exhaust vent was not very visible on the video. I mentioned it just after showing the solar panel. Also, one of the ...

Just an update to my project. Going in for surgery on the 18th... Wish me luck! 🤪 (It's age restricted because I'm growing my medicine) 😊

Besides, I was hoping that you continued it so I could plagiarize your work. 🤣

Pretty sure I didn't suggest that you let the wife get dirty by herself. That sounds more like @zander 😉

@inq How goes your project? I have an A/C getting delivered Friday because 125-130 degrees is just way too hot for any of my plants 🤨 Got my sur...

Hahaha! Probably will, will some poor unknowing family member all of my electronic gadgetry 🤣 Not being "classically trained" as you are, I will l...

It will run my pumps without a bunch of separate electronics mostly. And is very versatile as far as voltages, etc. Plus, it gives me lots of solder...

My doctor recommended it and prescribed it to me to replace all of the opioids I was on for pain. Got registered with the state, and I'm 100% legal ...

Yeah. Orchids. Let's go with that 😉

I decided to get a different board to handle my specific needs. I am including a PDF with the specs. It's a kit, so I will get my soldering on 😎

If you look closely between C4 & R4 on your sensors, there is no pinout hole to the left of them (in the one you have pictured). The bad ones (Fro...

@inq I forgot to mention that I will be using shielded wire (3 strand) for both the sensors and the pumps. 👍

I have 4 Earth Boxes... Each EB will have it's own sensor, as well as own pump. I'll have a holding tank for each pair of pumps so that I can monito...

No worries. I was just asking if you thought that it was a logical addition or not. Sorry 😉

@zander How much easier would it be to use the MKR Motor Carrier shield with my MKR 1010? It has native support for 4 DC motors (in my case water ...