
Last seen: 2023-01-09 7:06 pm
@inq Thnx for that, I learnt two things today, 1/ I learnt that if you had your adblocker on, you can't find the solved check box, & 2/ It tak...
Hi @inq, My bad, I didn't realize I had to mark this as solved! It is solved now, though everything you mentioned WAS a problem. I had to go to 80...
@will Sorry, your reply must have come in whilst i was writing my reply. As to your points. 1/ Yes, the platter will have a magnet inserted in it(...
@will Thanks! Yes, i have tested the pairs, & strangely, they are correct. :) This makes more sense, I've used 2 for STEP & 3 for DIR. The...
Hi @Will and @binaryrhyme Hi guys, Replying to BR first; !/ My designed circuit is not in use, just using my breadboard.2/ My cro detects PWM ...
@will am I missing something? I installed accelstepper, & then tried 'ConstantSpeed.pde' since it seemed the easiest to try first. The minimal c...
@will & @binaryrhyme Thank you both. Seems my Fusion 360 prowess is better than my stepper motor knowledge. The article Bill wrote, said that ju...
@Dronebot-Workshop (Bill) I picked up a USB C to USB Micro cable yesterday (the only one they had was 8" long, so now it dangles from the rear of my...
@dronebot-workshop (Bill) I've done as you suggested, & hooked up one of my Arduino boards, & as you foreshadowed, it works perfectly. W...
@Byron Thank you so much for that. I'd never had a problem on my previous Macbook pro, running Arduino's of all types. & had not even considered...
Thank you both, I've selected the DOIT esp32 Dev kit. I now get a "Native serial port, can't obtain info" error, so that's at least progress right? ...
@larry-manson &@MadMisha Thank you both for your replies. I program in C++, have done so since i learned it at university. I like the Arduino ID...