BBall Auto
BBall Auto
@bball-auto
Member
Joined: 2021-07-17 9:37 am
Last seen: 2021-07-22 11:46 pm
Topics: 2 / Replies: 11
Reply
RE: Linear actuator with DM542, 28BYJ-48, and Arduino

i'm reading some stuff on buttons now. i'll see what i can learn from that. Thanks

3 years ago
Reply
RE: Linear actuator with DM542, 28BYJ-48, and Arduino

@will I have eliminated the servo. And i'm never going to push the button until the entire carriage to right, followed by pause, followed by carria...

3 years ago
Reply
RE: Linear actuator with DM542, 28BYJ-48, and Arduino

@will I've simplified. All i want to do now is the following: 1. If carriage is not at left start mark, place it there. 2. Arduino sits waiti...

3 years ago
Reply
RE: Linear actuator with DM542, 28BYJ-48, and Arduino

@will I would like to add in a button push below at the beginning of the void loop section that initiates the first carriage movement. The place is...

3 years ago
Reply
RE: Linear actuator with DM542, 28BYJ-48, and Arduino

@will i'd prefer to have a button to start the sequence. do you know how i would add one in that spot? Thanks

3 years ago
Reply
RE: Linear actuator with DM542, 28BYJ-48, and Arduino

@will i'm not sure i want to use limit switches anymore. i may be ok with the setup i've currently got (without sensors at the end) as long as i can...

3 years ago
Reply
RE: Linear actuator with DM542, 28BYJ-48, and Arduino

@will, thanks for hanging in there with me. I took a few hours, took some deep breaths and just read the stepper and stepper excel library pages. I ...

3 years ago
Reply
RE: Linear actuator with DM542, 28BYJ-48, and Arduino

@will thanks much for the code. i'll try it. when it comes to the code, i've pretty much been grasping at straws because with my limited time i ...

3 years ago
Reply
RE: Linear actuator with DM542, 28BYJ-48, and Arduino

@madmisha and @will, Thanks much for the thoughts and help. My regular responsibilities have kicked me off this side project more than I’ve wanted ...

3 years ago
Reply
RE: Linear actuator with DM542, 28BYJ-48, and Arduino

@will Thanks much for the ideas. I'm able to devote some time to this immediately. Some questions before jump on the attempt: 1. Regarding your ...

3 years ago
Reply
RE: Thanks for being there for a newbie!

Thanks! that brings back memories from 89 when i graduated BSEE... there was a lab with perhaps 5 PCs and one laser printer for the entire departmen...

3 years ago
Topic
Topic
Replies: 5
Views: 1080