C++ is case-sensitive, so SETmtu, setMtu and setMTU are different names. With the ESP32 Arduino BLE library, the usual call is: ...

Hi, Since the ESP32-C6 is already online and you can read the chip temperature under Devices, the sensor/device side is probably working fine. The e...

1. Could this be power related rather than software load?Yes .... definitely possible .... When Wi-Fi traffic increases:RF section draws burst current...

Yeah, both points above are spot on. In general, 1.5–2 cm is definitely on the longer side for decoupling caps, especially for MCUs. It might still wo...

Even if somebody replicates it, I think some mismatches will be always there.

Some more information about this issue./p>

It's not possible to direct you to a fully finished tutorial that uses the exact parts that you've mentioned. However, you'll find several tutorials t...

It looks life the ARduino UNO R4's Wifi disconnection problem is not uncommon. You may find some clues from the following discussions.

Hello and welcome. Waiting to see your works.

Welcome to the forum.

Are dronebot workshops online? Can anybody join from any country?

Did you try pressing RST button?  

Use the MOSFET as a low-side switch. Drive the gate as high as possible. Ten volts gives the lowest on-resistance. Five volts works only for lighter l...

Yes, an oscilloscope is very useful for RFI diagnostics. It shows noise, glitches, and timing problems directly. It is not overkill for occasional ele...

Hello and welcome.