Hi Eric ... Yes I will be ready at 14.00 hrs UK time ... just getting setup..all family out with Grandson today so its peace ...

John

Hi John, here is today's link : https://discord.gg/Djcw49

Its Okay Eric I will leave till Saturday, was just having a quick test and fault find, got a bit late know..

John

Hi John, here is a new invite link, valid for the next 6 hours : https://discord.gg/2Dzyph

Hi Eric I was just a quick update which may help to fault find,

When I run the program with Serial Monitor I can see that "Switch States" line change's from 1 to 0 when I press Point buttons or switch the SPST switch for any 1 thro 5 i.e 1,1,0,1,1 for 3 etc the "Track States" always stay at 1 except as below, on each pass of a point on the loop you have a 1 second delay between each point and the 1A track position goes from HIGH to LOW for a fraction of a second each time none of the others change and that is with all points outputs HIGH..

One other thing if I switch point 5 so "Switch State" on  serial monitor goes LOW i.e 1,1,1,1,0 and "Track States" goes LOW after next pass i.e 1,1,1,1,0 but none of the other "Track States" change when switched...

But no outputs to switch point pins 11,12,13,14,15 all stay HIGH...

Hope this helps..

Regards John

Hi Eric sorry I missed your posts, leave till Saturday for 2.00pm as all family going out so no distractions..

No worry John, if you are around and want to setup before saturday, just ping me with an @-mention.

Posted by: @john40131

One thing you could look at why trackswitch 1 thro to 5 is not having any response on Mega output or what do I need to look for to change..

I guess we'll make a small test script to check that

Hi Eric sorry I missed your posts, leave till Saturday for 2.00pm as all family going out so no distractions..

One thing you could look at why trackswitch 1 thro to 5 is not having any response on Mega output or what do I need to look for to change.. 1072 

John

Hi john, if you want to setup a connection to the small discord server i have setup, the following link will be available for the next 6 hours (and then it will expire) : https://discord.gg/FDuruQ

Also I'm available from now until 8.30pm my time, which is 7.30pm UTC

Sorry, I don't touch facebook, linked-in, twitter, and other such "social" thingies.

Yes I have used pins 20 thro to 24 also has you have defined in lines 143 to 147 and as its a pullup I ground this pin, at the moment all switches are open so all 5 inputs are HIGH, I am going to change to momentary switches later this afternoon just need to remove SPST and fit pushbuttons.

John

Just a thought I use Messenger a lot i.e facebook messenger if would be easier can search for me..can send you pictures as well.. picture of (small dog with toy in mouth). John Marshall.